PUR (Plus Faucet Filtration) faucet water filters have some of the best certifications when it comes to filtration. They are among the easiest to use as well. PUR uses coconut shells to produce their own activated carbon to filter any contamination from the water faucet.

Whether you are thinking of acquiring one, or you’ve already done it, installing it the proper way is always important. So, if you want to know how to install a PUR water filter, you’ve come to the right place.

In this article, you’ll explain in detail how to install it the proper way.

Step-by-Step Guide to Installing the PUR Water Filter

The good news is, that installing the PUR faucet water filter is quite easy and straightforward. And they come with everything you need in the box, so you don’t need to buy any special tool to install them. However, you should be careful during the whole installation process, not to damage your faucet.

Here’s a step-by-step guide on how to install it, or rather attach it to your sink faucet.

Step 1: Unbox and Check Everything

Before starting the actual assembly process, make sure you have the following things handy.

• The Filter Unit
• Filter Cartridge
• Multiple Adapters (you’ll only need one, according to your faucet size)
• Multiple Rubber Gaskets.

Step 2: Install the Adapter

Remove the removable round tip from your faucet end (every standard sink faucet’s rounded end is removable). Unscrew that tip, you’ll find an aerator there, It’s the net-like thing that mixes air with water inside your faucet. Remove the aerator.

Now try different adapters to see which one matches your faucet perfectly. Once you get the perfect match, screw the adapter onto the faucet. Make sure that you have put the rubber gasket on the faucet before screwing it in.

Now move on to the next step.

Step 3: Install the Filter

Take the filter unit and unscrew it. inside, you will find room for the filter cartridge. Unwrap the cartridge from its plastic wrappings and place it inside the filter unit. Screw the top portion of the filter unit back on.

Now take the whole filter unit and push it onto the faucet. Keep pushing gently until you hear a click. if you’ve heard the click sound, you’ve successfully installed your PUR water filter.

After installation, before using it for the first time, run it on cold water for at least five minutes. After that, the PUR water filter is ready to use. Now whenever you turn your faucet on, you’ll get filtered water from it.

Tip: The indicator light on your PUR faucet filter is blinking six times when you turn on the faucet, it is working. If not, reassemble it.

Frequently Asked Questions and Answers

Which way does a PUR water filter go in?

There’s a front arrow on the cartridge of the filter. Line it up with the PUR logo that is on the front.

How do you remove a PUR water filter from a faucet?

You’ll find small white buttons on both sides of the adapters. Squeeze them both at the same time and pull the filter unit down. It should come right off.

Can I install a water filtration system myself?

Yes, for small home water filtration solutions, you can install them yourself.

How long do you flush a PUR water filter?

After a cartridge change or first installation, flush it for at least five minutes.

Conclusion

With bottled water prices sky-rocketing left right and center, you should really look into the faucet filtration system. They don’t cost as much as their bigger siblings. Plus, PUR-filtered water tastes good, they remove that chlorine taste from the tap water. Also, they add necessary minerals to your water.

Installing the PUR water filter is easy and takes less than a few minutes. They come pre-installed with warning lights as well. When the warning light turns red, you should change the cartridge immediately. Thanks for reading.